Telebyte Model GHN-SP-UPLC Universal Powerline Communications Splitter isolates PLC signal from AC power and splits to 3 BNC ports. Use as Line Impedance Stability Network (LISN).

Model GHN-SP-UPLC
Universal Power Line Communications Splitter

Datasheet

The Model GHN-SP-UPLC Universal Powerline Communications Splitter device is used to provide a controlled AC port to the PLC modem, separate and isolate the high-frequency PLC signal from AC power, and make it accessible on three BNC ports labelled L1, L2 and L3 with a controlled impedance. Having the PLC signal on BNC ports allows using standard instruments and accessories to perform measurements and build controlled topologies. Capable of performing Dynamic PSD Test and Cognitive Frequency Exclusion test (Dynamic Notching) per EN 50561-1 using Telebyte’s Model 501 and 501-Probe-Coax.

GHN-SP-UPLC BACK VIEW
MAIN FEATURES
Similar to AMN / LISN specified in CISPR-16, extending the concept to all three lines
Suitable for all types of broadband MIMO PLC (not valid for narrowband PLC < 2 MHz)
Basic building block for TR-208 and EN-50561 tests
High performance AC filter which provides high isolation with similar common-mode and differential-mode impedance on each line, L1, L2 and L3
Provides galvanic isolation and common-mode filtering to prevent PLC leakage on data port
BNC connectors for High Frequency signals on L1, L2, and L3
Embedded Zero-Cross Detector for AC-synchronized measurements and tests
Used with Telebyte Noise Generator for WT-208 testing
Used with Telebyte Digital Analyzer for ITU-G.9964 PSD, CENELEC EN 50561-1, EN 50561-3 measurements
Adaptors for Telebyte Model GHN-SP-UPLC.
ADAPTORS AVAILABLE FOR MULTIPLE REGIONS
Telebyte Model GHN-SP-SPLCOMB-3 symmetrical power splitter used with Telebyte Model GHN-SP-UPLC.

Model GHN-SP-SPLCOMB-3

A symmetrical power splitter and combiner where all the ports have 6 dB attenuation to each other.

This product provides one set of three BNC ports on one side and two sets on either side. The spacing between connectors is the same as in the GHN-SP-UPLC Universal Powerline Communications Splitter, allowing the device to be connected directly using male-male BNC barrels to reduce the number of cables. (Unused ports of the 3-Channel Power Splitter/Combiner must be terminated with 50Ω.)

The GHN-SP-UPLC connected to the GHN-SP-SPLCOMB-UPLC-3